12 Intel® Server Chassis SC5400 Installation
For a four-drive SAS hot swap drive cage installation:
1. Connect the SAS data cables from the server board to the SAS connectors on the SAS backplane
(letter “A”).
2. Connect two power cables to the power connectors on the SAS backplane (letter “B”).
3. Connect the HSBP_A header or HSBP_B header on the server board to the IPMB connector on
the SAS backplane (letter “C”).
4. Install the SES cable (AXX4DRV3GEXP only)
5. Connect the SES cable to the back plane.
6. Install the SGPIO cable (AXX4DRV3GEXP only)
7. Connect the SGPIO to the back plane.
To Next Page
Loading...
