- 28 -
G31 Series User's Manual
4.5.6 Security setting
This item allows you to Chage Supervisor/User Password, Type the password, up to eight
characters, and press <Enter>. The password typed now will clear any previously entered
password from CMOS memory. You will be asked toconrm the password. Type the password
again and press <Enter>.
Note:
Don’t forget your password. If you forget the password, you will have to
open the computer case and clear all information in the CMOS before you can start
up the system. But by doing this, you will have to reset all previously set options.
• Boot Sector Virus Protection
Uses this option, may prevent the change hard disk boot-sector (district table), thus prevents
the infection computer virus.
BIOS SETUP UTILITY
Main Advanced Boot Security Power JUSTw00t! Exit
Security Settings Install or Change the
password.
←
Select Screen
↑↓
Select Item
Enter Change
F1 General Help
F10 Save and Exit
ESC Exit
Supervisor Password : Not Installed
User Password : Not Installed
Change Supervisor Password
User Access Level
Change User Password
Clear User Password
Password Check
Boot Sector Virus Protection
[Full Access]
[Setup]
[Disabled]
v02.61 (C)Copyright 1985-2006, American Megatrends, Inc.
To Next Page
Need help?
General
