EasyManuals Logo

Intel S3000AH - Entry Server Board Motherboard User Manual

Intel S3000AH - Entry Server Board Motherboard
74 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
14 Intel
®
Server Board S3000AH User’s Guide
Hardware Requirements
To avoid integration difficulties and possible board damage, your system must meet the
requirements outlined below. For a list of qualified components, see the links under
"Additional Information and Software."
Processor
Supports Dual-Core Intel
®
Xeon
®
processor 3000 series, Quad-Core Intel
®
Xeon
®
processor 3200 series, Intel
®
Pentium
®
processor Extreme Edition (S3000AHLX and
S3000AH only), Intel
®
Pentium
®
D processors, Intel
®
Pentium
®
4 processors, and Intel
®
Celeron
®
D processors in the Intel
®
LGA775 package. For a complete list of supported
processors, see the links under "Additional Information and Software."
Memory
The Intel
®
Server Board S3000AH provides four DIMM sockets across two banks. Bank
1 consists of DIMM sockets 1A and 1B. Bank 2 consists of DIMM sockets 2A and 2B.
Minimum memory operation is a single 256MB DIMM in socket 1A. This will provide
single-channel interleave. For dual-channel interleave, two identical DIMMs are required
in sockets 1A and 1B.
To operate in dual-channel dynamic paging mode, the following conditions must be met:
Populate two identical DIMMs in sockets DIMM1A and DIMM 1B.
Populate four identical DIMMs in each socket location.
Note: The use of three DIMMs is not supported. Use DIMMs that are the same type and speed.
Use of identical DIMMs is preferred.
DIMMs must meet the following requirements:
Use only DIMMs with DDR2 DRAM technology.
Use only DDR2-533 and DDR2-667 stacked DIMM modules.
In determining your memory requirements, the need for memory sparing or memory
mirroring must be considered. For a complete list of supported memory DIMMs, see the
links under "Additional Information and Software."
Power Supply
A minimum of 350 Watts is required. Your supply must provide a minimum of 2A of 5V
standby current or the board will not boot.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intel S3000AH - Entry Server Board Motherboard and is the answer not in the manual?

Intel S3000AH - Entry Server Board Motherboard Specifications

General IconGeneral
BrandIntel
ModelS3000AH - Entry Server Board Motherboard
CategoryServer Board
LanguageEnglish

Related product manuals