Intel SE7520BD2 User Manual

Server Utilities
20
3. From the root directory run MAKEFLPY.bat to create the two required BIOS update
floppies.
4. Boot the system with the first BIOS update floppy. When prompted, insert the
second BIOS update floppy to continue the BIOS update.
5. When BIOS flash update is complete, it will display a message that all writing and
verification of flash is done.
6. Power cycle the system.
7. Press <F2> to enter BIOS Setup, and re-enter the custom values recorded earlier.
Press <F10> to save the values and exit Setup.
8. In the unlikely event that a BIOS error occurs during the BIOS update process, see
Recovering the BIOS for instructions on performing a BIOS recovery.
Other bootable storage Update:
1. Copy the afudos.exe, f.bat, fbb.bat, and the .ROM files to a bootable storage such as
a USB DISK-ON-KEY.
2. Place the bootable storage such as USB DISK-ON-KEY containing the new BIOS
into USB port of the system, and boot to pure DOS mode (non hi-mem or memory
management environment).
3. Run fbb.bat (depending if the bootblock needs to be updated)
¾ fbb.bat : Updates both system ROM and bootblock.
Note : If running fbb.bat / f.bat, jumper J1B1 (BIOS partition
selection) should be set to pins 1-2 to select the correct BIOS
partition.
4. When BIOS flash update is complete, it will display a message that all writing and
verification of flash is done.
5. Power-cycle the system.
6. As the system restarts, press <F2> to enter BIOS Setup, and re-enter the custom
values you wrote down in step 3. Press <F10> to save the values and exit Setup.
✏
NOTE
CMOS should always be cleared after a BIOS update. You may
encounter a CMOS Checksum error or other problem after reboot. If
so, try shutting down the system and restarting. CMOS checksum
errors require that you enter Setup, check your settings, save your
settings, and exit Setup.

Intel SE7520BD2 Specifications

General

Brand	Intel
Model	SE7520BD2
Category	Server Board
Language	English

Summary

Preface

Safety Information

Details critical safety warnings, precautions, and handling procedures for system operation.

Server Board Features

Hardware Installations and Upgrades

Before You Begin

Advises to review safety information before starting installations.

Installing and Removing Memory

Explains the process for installing and removing memory modules.

Installing or Replacing the Processor

Guides on installing or replacing the system's processor.

Installing the Heat Sink(s)

Provides instructions for installing the processor heat sink.

Removing a Processor

Details the procedure for removing the processor from the socket.

Installing or Removing a PCI Card

Explains how to install or remove PCI expansion cards.

Replacing the Backup Battery

Guides on how to replace the system's backup battery.

Server Utilities

Using the BIOS Setup Utility

Explains how to navigate and use the BIOS Setup utility.

Upgrading the BIOS

Provides instructions for updating the system BIOS.

Crisis Recovery Diskette

Explains how to create a crisis recovery diskette for BIOS.

Recovering the BIOS

Details methods for recovering the BIOS if it becomes damaged.

Clearing the Password

Clearing the CMOS

Troubleshooting

Resetting the System

Problems following Initial System Installation

First Steps Checklist

Hardware Diagnostic Testing

Specific Problems and Corrective Actions

BIOS POST Beep Codes

POST Error Beep Codes

Troubleshooting BIOS Beep Codes

Getting Help

World Wide Web

Telephone