Intel® Server RAID Controller U3-1 User’s Manual Rev 1.0 C-5
Error Messages Defined
1504 – Set Parameters Message Returned Error Status
1505 – Bad Result Count Returned from Message
1506 – Get/Set Parameters Function Returned Error Status
1507 – IOP Could Not Respond to Get Capabilities Query
1508 – Get Parameters Message Returned Error Status
1509 – Get Capabilities Query returned Bad Result Count
1510 – Unable To Get Status of the Firmware Download File
1511 – Unable to Read the Firmware Download File
1512 – Send Message to Initiate Firmware Download Returned Error Status
1513 – Could Not Allocate Memory for IOP Info Structure
1514 – Could Not Allocate Memory for Internal Buffers During IOP Init
1515 – Could Not Allocate Memory for List of IOP Handles
1516 – Get Configuration Dialog Request Failed
C.2.3.2. Firmware Update Utility Errors (Error Code Range = 1600 to 1749)
These error messages are reported in the following format:
ERROR xxxx: Error description
The xxxx is the error code. The phrase ‘ERROR xxxx:’ is in red text and will be blinking. The
error description then describes the error and how to resolve the problem.
Error Codes
1600 – No IOP Found
1607 – DIT Not Present
1608 – More Than One IOP Found
C.2.3.3. Firmware Update Utility Warnings (Error Code Range = 1750 to 1999)
A warning message informs the user of a situation that will not prevent the software from running,
but could have undesirable consequences. For example, a warning could be a message that informs
the user that deleting a RAID volume would result in the loss of all data.
These error messages are reported in the following format:
WARNING xxxx: Warning description
The xxxx is the warning code. The phrase ‘WARNING xxxx:’ is in light yellow text and will be
blinking. The warning description describes the warning symptom.
Warning Codes
1751 – Do you want to exit the RAID Configuration Utility?
Download from Www.Somanuals.com. All Manuals Search And Download.
To Next Page
Loading...
Need help?
General
