Intelbras ACtion RF 1200 - Page 31

31
Login password
Login password conguration screen
To change your router’s web conguration interface password, you must ll in the elds shown and click Save .
When you do this, you will be directed to the screen where you should log into your router’s web conguration interface,
using the new password you registered.
Restart/Factory Default
Screen with restart options and factory default
If you wish to restart your router, you can perform this procedure in two ways:
1. Through the web conguration interface, in the menu System Settings>Restart/Factory Default, click on the button
Restart and wait, following the on-screen instructions;
2. You can simply remove the power cord from your router and plug it in again, or remove the power supply from the outlet
and plug it in again;
Through this screen you can also return the ACtion RF 1200 to factory default settings. In this case, all your current
settings will be lost.
To restore the product to factory default settings via the web conguration interface:
1. In the menu System Settings>Restart/Factory Default of the web conguration interface, click the button Factory Default;
2. Wait while the conguration is restored, following the directions displayed by the web interface.
To restore the product to factory default settings via the physical RST/WPS button:
1. Plug the router into the outlet and wait for it to start (SYS led ashing);
2. Press the button RST/WPS , located on the back of the ACtion RF 1200, for about 20 seconds until the LEDs light up (1
second) and turn off afterward;