Intelbras AMT 2018 E - Programming Guide; Password Management

27
To reset from programming mode, type:
1. Access the center with the installer password;
2. Type: Enter + 0000 + Enter .
Note.: this command does not erase the wireless devices registered in the center, nor
the editable messages, except the name of the center.
4.4. Wireless device Reset
This command erases all programmed wireless devices. If Reset Lock is enabled, this
function will not be available.
To reset the wireless device, type:
1. Access the center with the installer password;
2. Type: Enter + 7 + Cancel + Enter .
5. Programming
To perform other programming or to get more detailed information about the center,
access the complete manual at www.intelbras.com.br.
Enter programming mode
Settings Result
Installer Password
ENTER + INSTALLER PASSWORD
Factory default: 9090
Enters programming mode, changes the installer’s own password
and the alarm center settings.
Master Password
ENTER + MASTER PASSWORD
Factory default: 1234
Congure secondary passwords and change the master password
itself, give permissions to the secondary passwords, cancel zones of
the center by programming mode and view the cancelled zones. With
this password it is also possible to program the remote control, test
sensors, test the wireless sensors’ batteries, adjust the date, time and
day of the week, edit the XAT 2000 LCD/XAT 4000 LCD keyboard
messages.
Register or change Password
Settings Result
Password registration
ENTER + MASTER PASSWORD
Factory default: 1234
ENTER + 20 +
USERNAME +
PASSWORD + ENTER
Note:
» User Number = 00 to 61
» 4 or 6 digit registered password
Deleting Password
ENTER + MASTER PASSWORD
Factory default: 1234
ENTER + 20 + USER
+ ENTER
Note:
» User Number = 00 to 61
Password registration
ENTER + INSTALLER
PASSWORD
Factory default: 9090
ENTER + 20 +
USERNAME +
PASSWORD + ENTER
Note:
» User Number = 62 to 63
» 4 or 6 digit registered password
» Password for User 63 must have 6 digits
Deleting Password
ENTER + INSTALLER
PASSWORD
Factory default: 9090
ENTER + 20 + USER
+ ENTER
Note:
» User Number = 62 to 63