Intelbras AMT 2018 E - Page 38

38
Phone for SMS
Settings Result
Enable
Disable
ENTER + INSTALLER
PASSWORD
Factory default: 9090
ENTER + 84 + 1
TYPE TELEPHONE +
ENTER
Note:
» Telephone: up to 20 digits
» Factory default: blank.
ENTER + 84 + 2
TYPE TELEPHONE +
ENTER
Note:
» Telephone: up to 20 digits
» Factory default: blank.
ENTER + 84 + 3
TYPE TELEPHONE +
ENTER
Note:
» Telephone: up to 20 digits
» Factory default: blank.
ENTER + 84 + 4
TYPE TELEPHONE +
ENTER
Note:
» Telephone: up to 20 digits
» Factory default: blank.
ENTER + 84 + 5
TYPE TELEPHONE +
ENTER
Note:
» Telephone: up to 20 digits
» Factory default: blank.
General Settings
Settings Result
Enable
Disable
ENTER + INSTALLER
PASSWORD
Factory default: 9090
ENTER + 510 + ENTER 1 + ENTER
Note:
» Enables partitioning of the center.
» Factory Default: Disabled.
ENTER + 510 + ENTER 2 + ENTER
Note:
» Activates the center by pressing the
ACTIVATE key for 3 seconds.
» Factory Default: Disabled.
ENTER + 510 + ENTER 3 + ENTER
Note:
» The center’s siren will emit 1 beep upon
activation and 2 beeps upon deactivation.
» Factory Default: Enabled.
ENTER + 510 + ENTER 4 + ENTER
Note:
» Activates the center even if a Zone is open.
» Factory Default: Disabled.
ENTER + INSTALLER
PASSWORD
Factory default: 9090
ENTER + 510 + ENTER 5 + ENTER
Note:
» Enable 6-digit User Passwords.
» Factory Default: Disabled.
ENTER + 510 + ENTER 6 + ENTER
Note:
» The system will activate in night mode if it is
not partitioned, or only Partition A will acti-
vate if it is partitioned.
» Factory Default: Disabled.
ENTER + 510 + ENTER 7 + ENTER
Note:
» Only Partition B will be activated if the sys-
tem is partitioned.
» Factory Default: Disabled.