Interlogix FP 2000 Series - Panel & Repeater Layout; Figure 3: Panel Layout

FP/FR1100/1200/2000 V6: Installation and Commissioning Manual 17
CAUTION! Mains wires (230 V) must enter the cabinet from the right bottom hole in the
cabinet only.
Top entry violates IEC950 safety requirements and will cause EMC
problems.
Mains wires must not be routed past the electronic modules in the rear of the panel. It
must be kept as short as possible and routed directly to the mains input.
4.1.3 Panel & repeater layout
Figure 3: Panel layout
A. FP1216EN & FP1264 16. Host CPU board
B. FR1200 & FR2000 17. DB-9 port
1. Transformer 18. RS232 and current loop routing of wires
2. Battery link 19. ARCNET network card (top) (optional)
3. Battery terminal (+) (red) 20. Battery terminal (-) (black)
4. Mains terminal block 21. Battery and power supply connection terminals
5. Earth stud 22. Modem (MOD2000) power supply terminals
6. Main fuse and switch 23. Front-end processor board
7. Batteries 12V (2x) (optional) 24. Power supply board
8. Zone matrix display board (bottom) (optional) 25. Fault relay connections
9. Common LED board 26. Auxiliary power connections
10. Service commission mode select 27. Loop 1-4 terminal connections
11. Non-volatile memory lock 28. 2 Loop driver board
12. Memory back-up battery jumper 29. Sounder relay board
13. Numeric keypad 30. Modem (MOD2000) (optional)
14. LCD display 31. ARCNET network card (bottom) (NC2011)
15. Current loop terminals