FP/FR1100/1200/2000 V6: Installation and Commissioning Manual 41
6.4.2.3 Power supply connections
1. Ensure that the mains power is disconnected before opening the unit.
2. Connect the fault relay as shown in figure 31.
3. Route the wires away from sharp edges and corners and fix them into position.
Figure 31: FP/FR12xx power supply’s fault relay connections
1. Normally open 3. Normally closed
2. Common
Fault output (NC) ((Jumpers default position - A)
J10 (Pins for position A connected on PCB) Position A = 660 ohm
Position B = 0 ohm
J11 (Pins for position B connected on PCB) Position A = 3.3k ohm
Position B = 0 ohm
Note: Resistors shown are mounted on the PS1200 board
To Next Page
Loading...