32 FP/FR1100/1200/2000 V6: Installation and Commissioning Manual
J5 out J5 in
OUT 4 (Refer to positions 6 in figure 13.)
The configurations for OUT 4 are shown below (FAIL-SAFE). The switch is closed when
there is a fault. The LED is ON when there is no fault.
Figure 22: Two configurations for relay output 4 B
Outputs CONFIG. 1 CONFIG. 2
Fault routing OUT4 J6 in
J7 out
J6 out
J7 in
Figure 23: Location of jumpers on sounder board
1. Sounder board 6. Fire alarm device (Out1)
2. Programmable relays (A – Out8, B – Out7, C – Out6, D
– Out5)
7. Input 8
3. Fault routing (Out4) 8. Input 7
4. Fire protection device (Out3) 9. Input 6
5. Fire routing device (Out2) 10. Input 5
To Next Page
Loading...