Interlogix TruVision NVR 10 - Configuring the Camera OSD Settings

TruVision NVR 10 User Manual 65
Figure 11: IP camera window
Network parameter window
List of IP cameras found on the network
List of IP cameras added to the NVR.
The columns of camera information are: Camera no., Status, PoE Port, Edit, Advanced Set, View,
Camera name, IP Camera Address, Management Port, Protocol, Device Model, Serial Number, and
Firmware.
1. Quick Add: Add the selected cameras from
the search results list to the NVR system
without modifying the camera configuration.
2. Search: Search the network for available IP
cameras.
3. Add: After entering the details of a camera in
the configuration window, add it to NVR
system.
4. Upgrade: Upgrade IP camera software. Insert
USB flash drive in NVR and select the file to
upgrade. The camera will automatically
reboot once the software is upgraded.
5. Delete: Delete the selected IP camera.
6. Refresh: Update the information displayed on a
camera in the NVR device list.
7. Edit: Change the information on the selected IP
camera.
8. Advanced Settings: Add or change the IP
address of the selected camera as well as
change its password.
9. Live View: View the selected IP camera.
10. Camera status indication:
Green = Plug-and-Play cameras; Red =
Disconnected cameras; Yellow = No Plug-and-
Play cameras.
To automatically add an IP camera:
1. From the menu toolbar, click Camera Management > Camera.
2. Click Search to locate any IP cameras located in the NVR LAN. When the search is
complete, a list of the available cameras is shown.
3. Check the boxes of the desired cameras that you want to add to the NVR system.