Interlogix xGen Lite

74 xGen Lite Installation and Programming Guide
Backup Z-Wave Network
The panel contains a database of all Z-Wave devices and the network
configuration. This is separate from the panel programming, and wireless
transmitter devices. The Z-Wave Network can be backed up to the internal
memory of the panel or downloaded to a computer using DLX900.
To perform a backup of the Z-Wave Network:
1. Click Settings > Zwave Maintenance.
2. Click the Backup button.
Status will show “Backing Up Network”.
Status will show “Network Backed Up” when successful.
Reset Z-Wave Network
The panel contains a database of all Z-Wave devices and the network
configuration. The Z-Wave Network can be cleared without affecting panel
programming.
To reset the Z-Wave Network back to factory defaults:
1. Click Settings > Zwave Maintenance.
2. Click the Reset button.
3. Click OK to warning message.
Status will show “Resetting Network”.
Status will show “Network Reset” when successful.
Restore Z-Wave Network
The panel contains a database of all Z-Wave devices and the network
configuration. If a backup has been previously made, the Z-Wave Network can
be restored.
To perform a Z-Wave Network restore:
1. Click Settings > Zwave Maintenance.
2. Click the Restore button.
Status will show “Restoring Network”.
Status will show “Restore Complete” when successful.
Allow a few minutes for the network to refresh itself before programming devices.