xGen Installation & Programming Guide 101
Menu Overview
Instructions
1. Go to Channels
2. Enter an Account Number up to 8 digits, hex values are accepted
3. Select the Format of the communication channel, this will automatically use
the settings programmed for that Format in the Communicator menu
4. Select the reporting device, by default Device 1 is the xGen panel
5. Enter the destination phone number, email address or IP address depending
on which Format you selected
5. Channels
18. Channel Groups
6. Communicator
17. Event Lists
18. Channel Groups
6. Communicator
a) Options
b) IP Config
c) Ethernet
d) Radio
e) Dial IP
f) Email
g) Remote Access
h) System Event Reporting
17. Event Lists
To Next Page
Loading...
Need help?
General
