xGen Installation & Programming Guide 45
System Status Messages
Various messages may appear on the Status screen of xGen Web Server and
UltraConnect app.
System
• AC power fail – The security system has lost its electricity power
• Low battery – The security system’s back up battery requires charging
• Battery test fail – The security system’s back up battery requires changing
• Box tamper – The security system’s cabinet tamper input has activated
• Siren trouble – The security system’s external siren has a problem
• Over current – The security system is drawing too much current
• Time and date loss The security system time and date need resetting
• Communication fault – The security system has detected a problem with the
phone line
• Fire alarm – A fire alarm has been activated from the xGen unit
• Panic – A panic alarm has been activated from the xGen unit
• Medical – A medical alarm has been activated from the xGen unit
Partition Number. Partition Name
• Is On in the away mode – This Partition is armed in the away mode
• Is On in the stay mode – This Partition is armed in the stay mode
• Is ready – This Partition is secure and ready to be armed
• Is not ready – This Partition is NOT ready to be armed, a zone is not secure
• All Partitions are on in the away mode – All Partitions in this multi partition
system are armed in the away mode
• All Partitions are on in the stay mode – All Partitions in this multi partition
system are armed in the stay mode
• All Partitions are ready – All Partitions in this multi partition system are secure
and ready to be armed
Zone Number. Zone Name
• In Alarm – This zone has triggered a system alarm condition
• Is bypassed – This zone is isolated (disabled) and will not activate an alarm
• Chime is set – This zone is part of the chime group
• Is not secure – This zone is not closed
• Fire alarm – This zone has triggered a fire alarm
• Tamper – This zone has triggered a tamper alarm
• Trouble fault – This zone has an open circuit
To Next Page