Intermec CK3R

Chapter 3 — Configure the Computer
CK3R and CK3X Mobile Computer User Manual 65
Configure WPA or WPA2 Enterprise (802.1x) Security
with Microsoft Security
Before you set WPA-802.1x or WPA2-802.1x security with Microsoft,
you need to configure your authentication server and authenticators.
To use TLS protocol, you also need to load a user and root certificate.
On your computer, you need to enable the radio and set the date.
1 Start Intermec Settings.
2 Select Communications > 802.11 Radio > Microsoft Security.
3 Enter the Network name (SSID).
4 For Infrastructure Mode, select Infrastructure.
5 For Network Authentication, select WPA or WPA2.
The default encryption is TKIP or AES, respectively.
6 For 802.1X Authentication, select TLS or PEAP.
7 Select Hidden Network.
8 Tap OK. The User Logon dialog box appears.
9 If you selected PEAP:
a Enter a User Name, Password, and Domain.
b If you want to save the password for future authentication
sessions, select Save Password.
10 If you selected TLS, enter a User Name and Domain.
11 Tap OK.
Configure WPA or WPA2 Personal (PSK) Security with
Microsoft Security
Before you set WPA or WPA2 Personal (PSK) security, you need to need
to know the pre-shared key for your access point or passphrase for
your authenticator. On your computer, you need to enable the radio
and set the date.
1 Start Intermec Settings.
2 Select Communications > 802.11 Radio > Microsoft Security.
3 Enter the Network name (SSID).