Intermec PB51 - Media Specifications

Chapter A — Specications
PB51 Mobile Label and Recept Printer User’s Guide 53
Receipt roll stock media is supplied as a continuou s roll. Label, tag,
and fanfold media use repeat indicators for non-con tinuous media.
Gap, notch, and black marks are used as repeat indi cators:
tGap: Label and fanfold media
tNotch: Tag media
tBlack mark: Label, tag, and fanfold media
Here are a few things to keep in mind when ordering media for the
PB51 printer:
tBlack marks can only be sensed on the back side of the media.
tYou can use higher caliper media in the printer, bu t print quality
will be reduced.
tReceipt roll stock media has an end of roll indicat or. The end of
roll indicator is a red marking (on last 3 feet of roll) on the
thermally sensitive side of the paper.
Media Specications
Core inside diameter, standard: 19 mm (0.75in)
Core inside diameter, with adapter: 10.2 mm (0.4 in)
Maximum roll outside diameter: 67.3 mm (2.65 in)
Media width, label with liner/receipt: 49mm (1.9 in) to 111.5 mm (4.4 in)
)ni 42( mm 6.906 ot )ni 0.1( mm 4.52:lebal ,htgnel aideM
suounitnoC:tpiecer ,htgnel aideM
Media caliper, label with liner/receipt: 0.05 mm (0. 002 in) to 0.165 mm (0.0065 in)
Media caliper, tag (maximum): 0.15 mm (0.006 in)
Gap length (centered on perforation): 3.17 mm (0.125 in) to 12.7 mm (0.50 in)
Notch length (centered on perforation): 6.35 mm (0.2 5 in)
Notch width (centered on perforation): 12.7 mm (0.50 in)
Black mark length (centered on perforation): 3.17 mm (0.125 in) to 12.7 mm (0.50 in)
Black mark width (centered on media width): Full wid th of media