Intermec PB51 - Page 64

Chapter A — Specications
54 PB51 Mobile Label and Recept Printer User’s Guide
Specialty media is required for unique customer environments,
including printer operating temperature extremes. Media
performance is format and environment dependent. Not all media
will work in all customer applications. Intermec recommends that
you test the media in your application.
Supported Media
The PB51 printer supports direct thermal label, tag , and receipt
media. Both North American and European label media are
supported in multiple label lengths. Receipt media is supported in
both a top coated and an uncoated paper in continuous roll stock
only.
The default media sensitivity number is 180.
The default media sensitivity number for linerless media is 103
Use the following table as a guide when setting sensitivity numbers.
External Fanfold Media Specications
Stack height: 70 mm (2.75 in)
Page length: 152 mm (6 in) to 305 mm (12 in)
Note: A 6-inch page length is supplied in 12-inch long st acks (two 6-
inch stacks of equal height with the bottom page linked).
Recommended Media Sensitivity, Constant, Factor, an d Print Speed
Sensitivity Constant Factor Description Max Print Speed
North American Label Media
720 60 40 Duratherm Lightning Plus 4 ips
470 52 40 Duratherm Lightning 4 ips
450 48 40 Duratherm Lightning 2 ips
430 100 40 Duratherm Synthetic 4 ips
180 80 40 Duratherm II Label 4 ips
180 80 40 Duratherm III Label 4 ips
180 80 40 Duratherm Near IR 4 ips
150 50 40 Duratherm 5 mil Tag 2 ips