Intermec PM4I Installation Instructions

54 EasyLAN Wireless Interface Kit Installation Instructions
Chapter 5 — Setup in IPL
 e following regulatory domains are implemented:
Value Countries Allowed channels
FCC (or USA) U.S.A 1-11 (default)
IC (or Canada) Canada 1-11
ETSI (or EU) EU countries
1
+ Iceland,
Liechtenstein, Norway, and
Switzerland
1-13
MKK (or Japan) Japan 1-14
1
/. Certain restrictions apply to outdoor use in France.
<STX><SI>wt,.REGION<ETX>
Transmits the active region.
Finishing the Wireless Setup
You can now disconnect the printer from the PC. You still need to assign
an IP address, subnet mask, default router, and name server.  is can be
done via the printer’s display and keyboard (provided the server supports
DHCP or BOOTP). If not, you must rely on wireless communication
and use the ARP’n’PING method, which require that there is a work-
ing wireless LAN and the printer is inside the coverage area of an access
point.

Intermec PM4I Specifications

General

Print Technology	Direct thermal / Thermal transfer
Resolution	203 dpi
Max Print Width	4.09 inches
Connectivity	USB, Serial, Parallel
Optional Connectivity	Ethernet, Wireless
Memory	16 MB SDRAM, 8 MB Flash
Operating Temperature	+5°C to +40°C (+41°F to +104°F)
Storage Temperature	-20°C to +60°C (-4°F to +140°F)