Intermec PM4I - Loading Ribbon

Intermec EasyLAN Wireless—Interface Kit Installation Instructions 31
Chapter 4—Setup in IPL
Setting Up Network Parameters
You can now disconnect the printer from the PC. Still it remains to
assign IP address, netmask, default router, and name server. This can
either be done via the printer’s display and keyboard (provided the
server support either DHCP or BOOTP (or both). If not, you must rely
on wireless communication and use the ARPn’PING method, which
require that there is a working wireless LAN and the printer is inside the
coverage area of an access point.
IP Selection Method
There are four methods for setting the IP address. DHCP, BOOTP,
and DHCP+BOOTP let the server assign a temporary IP address to
the printer. Which method to choose depends on the server. DHCP,
BOOTP, and DHCP+BOOTP also sets the netmask, default router,
and name server automatically. If the server neither supports DHCP nor
BOOTP, you will have to use the ARP’n’PING method. The MANUAL
option is presently not supported by IPL.
Always consult the network administrator before assigning
a permanent IP address to avoid having more than one
device with the same IP address in the network.
• Press the Setup key on the printer’s built-in keyboard. This message
appears in the display window:
SETUP:
SER-COM
• Repeatedly press the → key until the following message appears:
SETUP:
NETWORK
• Press the ↓ key. The display shows:
NETWORK:
IP SELECTION
• Press the ↓ key. The display shows by default:
IP SELECTION:
DHCP+BOOTP