Intermec PM4I Installation Instructions

40 EasyLAN Wireless Interface Kit Installation Instructions
Chapter 4 — Setup in Fingerprint
Reading Wireless Connection Setup
All settings can be returned to the host via a specifi ed serial communi-
cation port, usually "uart1:", using the Fingerprint instruction SETUP
WRITE "wlan" or SETUP WRITE "8021x".
Example:
SETUP WRITE "wlan","uart1:”
yields for example:
SSID qwerty
WEP1 ****
WEP2 ****
WEP3
WEP4
.WEP_KEY 0
.REGION USA (FCC)
# CHANNEL 11
# AP_MAC 00:10:40:25:ee:a9
# SIGNAL 49
# SPEED 11
ACTIVE 1
Setting Up Network Parameters
In this document, the use of setup strings or setup fi les are described.
Network parameters could also be set via the printer’s built-in keyboard
as described in the printer user’s guide.
New Line
Set the New Line parameter using a setup string or setup fi le:
SETUP"NET-COM,NET1,NEW LINE,CR/LF"
SETUP"NET-COM,NET1,NEW LINE,LF"
SETUP"NET-COM,NET1,NEW LINE,CR"
Default is CR/LF.

Intermec PM4I Specifications

General

Print Technology	Direct thermal / Thermal transfer
Resolution	203 dpi
Max Print Width	4.09 inches
Connectivity	USB, Serial, Parallel
Optional Connectivity	Ethernet, Wireless
Memory	16 MB SDRAM, 8 MB Flash
Operating Temperature	+5°C to +40°C (+41°F to +104°F)
Storage Temperature	-20°C to +60°C (-4°F to +140°F)