Intermec EasyLAN Wireless—Interface Kit Installation Instructions 15
Chapter 3—Setup in Fingerprint
A reboot will cause the current settings to be used. The alternative to
rebooting the printer is the “ACTIVE” setting. Setting this to anything
other than a “0” will cause the current settings to be activated. Reading
the ACTIVE setting will indicate whether the current settings are being
used or not. 0 indicates that the current settings are not active (changes
have been made since startup or last non-zero setting of ACTIVE). 1
indicates that the settings are being used. ACTIVE cannot be set to 0
explicitly (but is implicitly set to 0 by changing another setting). Any
changes made on the web page(s) will be activated when the user submits
the form (given that the settings are correctly entered).
In Fingerprint, there is presently only one section with an “ACTIVE”
setting, “wlan” (regarding wireless LAN settings). An ACTIVE setting is
only valid for the setup section in which it belongs.
SETUP "wlan","ACTIVE","1" activates the current settings in the
“wlan” section (forcing a re-association).
SETUP GET/WRITE for “ACTIVE” will get 1 if the current settings are
in use, 0 if a setting has been changed.
To Next Page
Loading...
