Intermec PM4I - 3 Easylan Network Setup

Intermec EasyLAN Wireless—Interface Kit Installation Instructions 13
Chapter 3—Setup in Fingerprint
Changing User
To change the current user in Fingerprint, the “su”-command is used.
Syntax:
RUN"su [-p <password>] <user>"
su requests the password for <user>, and switches to that user after
checking the password fi le.
Valid <user> names are admin and user.
Everyone can become user even if user’s password is set.
No password is requested if the current user already is the one to switch
to.
The option is as follows:
-p password Don’t query for a password; use the one supplied at
the command line.
Note: Everything is case sensitive (user name, su command,
passwords).
Examples:
To become “admin”.
RUN"su admin"
Password:[enter password (default: pass)]
Ok
Or:
RUN"su -p pass admin": RUN"whoami"
admin
To switch back to user:
RUN"su user"