12 Intermec EasyLAN Wireless Interface Kit—Installation Instructions
Chapter 3—Setup in Fingerprint
Setting Up Wireless Communication
General
Once a wired serial communication is established, you can use Finger-
print setup strings or setup fi les to set up the necessary EasyLAN wireless
parameters. All settings are saved in fi les on the printer fl ash memory. If
a factory defaulting upgrade is performed, all settings described in this
section are set to their (factory) default values.
The default allowed user is “
admin”. All settings are restricted to read-
only for all users except the allowed user, who can change all settings. If
unauthorized access is attempted, error 1076 (Operation not permitted)
will occur. Settings beginning with a period “.” character are read-
protected from non-authorized users. Some settings are not possible to
read even by the allowed user, for instance WEP keys, which return the
same string regardless of the actual key.
Display Current User
To display who the current user is in Fingerprint, the “whoami”
command is used.
Syntax:
RUN"whoami"
Note: This command is case-sensitive.
The command echoes the current user to the standard out channel.
Example:
RUN"whoami"
user
Ok
To Next Page
Loading...
