Intermec EasyLAN Wireless—Interface Kit Installation Instructions 11
3
Setup in Fingerprint
This chapter explains how to set up the wireless
network communication in printers running Intermec
Fingerprint v8.10 (or later). The only requirement on
the PC side is a terminal program that can transmit
and receive ASCII characters on an RS-232 line.
Thus, this method is recommended when you do not
have the opportunity to run the Intermec EasyLAN
Network Setup wizard, for example because you use
some other operating system than Windows.
For information on how to set up the network
communication in printer’s running IPL, refer to
Chapter 4.
To Next Page
Loading...
