Intermec PM4I - Setup in Fingerprint

Intermec EasyLAN Wireless—Interface Kit Installation Instructions 17
Chapter 3—Setup in Fingerprint
Examples:
SETUP "wlan","WEP1","0x1138170147"
Sets key #1 (WEP 64, hexadecimal)
SETUP "wlan","WEP2","abcde"
Sets key #2 (WEP 64, alphanumerical)
SETUP "wlan","WEP3","0x123456789abcdef0123456789a"
Sets key #3, (WEP 128, hexadecimal)
SETUP "wlan","WEP4","abcdefghijklm"
Sets key #4 (WEP 128, alphanumerical)
SETUP "wlan","WEP2",""
Removes key #2
SETUP "wlan",".WEP_KEY","0"
Disables WEP
SETUP "wlan",".WEP_KEY","1"
Selects WEP key #1 for use in transmission (0-4 accepted)
SETUP WRITE/GET for WEP1-4 return empty string if that key is not
confi gured, “****” otherwise.
It is not possible for any user to read the WEP key(s).
WEP Enabled/Disabled is shown on the network test label. WEP is
deemed disabled if no key has been selected, or if the selected key is un-
confi gured.