Preface
For Users Outside of the United States and Canada
The Intermec product you purchased contains a Mode 802MIG2
transceiver module. This module transmits and receives data using a 2.4
GHz Direct Sequence Spread Spectrum system.
Please check the Intermec Web site for additional documentation at
www.intermec.com.
Hereby, Intermec Technologies Corporation declares that this Model
802MIG2 is in compliance with the essential requirements and other
relevant provisions of R&TTE Directive (1995/5/EC). This product has
been assessed to the following standards:
• ETSI EN 300 328-2 v1.2.1 (2001-12)
• ETSI EN 301 489-17 v1.1.1 (2001-09)
• EN 60950:1992 (incl. Amdt. 1-4,11)
The original Declaration of Conformity is available on the Intermec
Technologies Corporation Web site at www.intermec.com.
This product transmits electromagnetic waves at 2.4 GHz frequency
range. It has been tested and found compliant with U.S. (OET Guide
65) and Canadian (RSS 102) RF exposure regulations. There are no
regulations covering this product type in the European Union at this
time.
The transmitter module’s output power is 11.6 mW. The product using
this module are intended for business and industrial environments. They
should not be used in residential environments and by children.
This product is marked with this logo and uses
radio frequency bands that are not harmonized
throughout the European Union.
Intermec EasyLAN Wireless—Interface Kit Installation Instructions vii
To Next Page
Loading...
