Interpump SS71 - 5 Technical Characteristics; 6 Dimensions and Weight; 7 Operating Instructions; Water Temperature

ENGLISH
23
5 TECHNICAL CHARACTERISTICS
Model Rpm
Flow rate Pressure Power
l/min Gpm bar psi kW HP
SS 7193 1000 93 24.5 200 2900 35.3 48
SS 71106 1000 106 28.0 200 2900 40.4 55
SS 71153
800
900
1000
122
137
153
32.2
36.2
40.5
160
140
130
2320
2030
1885
37.5
36.8
38.2
51
50
52
SS 71170
SS 71170-F
900 170 44.9 100 1450 32.5 44.2
Model Rpm
Flow rate Pressure Power
l/min Gpm bar psi kW HP
SN 7193 1000 93 24.5 210 3045 37.5 51
SN 71106
SN 71106-F
1000 106 28.0 200 2900 40.4 55
SN 71153
SN 71153-F
800
900
1000
122
137
153
32.2
36.2
40.5
160
140
130
2320
2030
1885
37.5
36.8
38.2
51
50
52
SN 71170
SN 71170-F
900 170 45 110 1600 36 49
Model Rpm
Flow rate Pressure Power
l/min Gpm bar psi kW HP
SW71170 900 170 44.9 100 1450 32.5 44.2
6 DIMENSIONS AND WEIGHT
For Standard SS-SN-SW version pump dimensions and weight, refer to Fig.2.
Dry weight 68 kg. Fig.2
7 OPERATING INSTRUCTIONS
SS71 pumps, when not ordered with the ATEX conguration,
have been designed to operate in environments with
atmospheres that are not potentially explosive, with ltered
water (see par. 9.7) at a maximum temperature of 85°C,
with the head and all the components in contact with the
uid made of AISI 316L, plus special high and low pressure
energized seals. SN71 pumps, when not ordered with the
ATEX conguration, have been designed to operate in
environments with atmospheres that are not potentially
explosive, with ltered water (see par. 9.7) and at a
maximum temperature of 85°C, with the head made of AISI
420 and all the components in contact with the uid made
of AISI 316L plus special high and low pressure energized
seals. The SW71 pumps have been designed to operate in
environments with atmospheres that are not potentially
explosive, with ltered sea water (see par. 9.7) at a maximum
temperature of 85°C, with the head and all the components
in contact with the uid made of AISI 316L, plus special high
and low pressure energized seals. Other liquids can be used
only upon formal approval by the Technical or Customer
Service Department.
7.1 Water temperature
The permissible water temperature is 40°C.
However, the pump can be used with water up to a
temperature of 85°C.
In this case, it is best to consult the Technical or
Customer Service Departments.
7.2 Maximum pressure and ow rate
The rated specications stated in our catalog are the max.
that can be obtained by the pump. Independently of the
power used, the maximum pressure and rpm indicated on the
specication label can never be exceeded unless prior formal
authorization is given by our Technical or Customer Service
Departments.
7.3 Minimum operating speed
The minimum speed allowed for these types of pumps
is 100 rpm for non-continuous periods; any rpm other
than mentioned and shown in the performance table (see
chapter 5) must be expressly and formally authorized by the
Engineering Department or Customer Service.