Interquartz IQ335 - ADVANCED TELEPHONE FUNCTIONS; CALL MANAGEMENT FEATURES; DATA AND TIMER FEATURES

10
PAUSE FUNCTION
The Pause command may be needed if your phone is connected to any network where a momentary pause
is required (e.g. a PABX between internal and external dial tones).
For manual dialing
1. Lift Handset
2. Dial any digits required before the pause
3. Press PAUSE; the telephone will complete the dialing process once the Pause time has elapsed
4. Dial the remaining digits.
The Pause function can be stored in any Direct Access or Direct memories. See section 8 for further
details.
MUTE KEY AND INDICATOR
When pressed, it cuts off transmission from the handset, headset and handsfree microphones to allow
user privacy. The red light indicates when the mute condition is active. Press MUTE again to release
the mute condition.
HANDSFREE/HEADSET KEY AND INDICATOR
The HANDSFREE/HEADSET key has an auto-detection function; which disables the handsfree mode
when a headset is in use. When the HANDSFREE/HEADSET key is pressed, a red indicator will glow
to show that the handsfree or headset mode is activated. Press the key again to turn it off.
To use Handsfree mode
Ensure that a headset is NOT connected to the headset jack. Press the HANDSFREE/HEADSET key;
the telephone will automatically operate in Handsfree mode. A red indicator will glow to show that the
Handsfree mode is activated. Press the key again to turn it off.
To use Headset mode
Connect a headset to the headset jack. Press the HANDSFREE/HEADSET key; the telephone will
automatically operate in Headset mode. A red indicator will glow to show that the Headset mode is
activated. Press the key again to turn it off.
CURSOR AND KEYS
The Cursor functions of the and keys can be used when it is necessary to use the same key twice
in succession when entering text and they also serve as Edit keys during memory storage.
AUTOMATIC CALL TIMER
When a call is in progress, the word TIMER appears on the display, and the time will count from 00:00.
To use the timer as a call timer, the telephone will automatically enter the Timer mode when commencing
a call. The call duration will be displayed for 10 seconds after the call is terminated.
DATA PORT
The Data Port provides access to the telephone line for computers (with a modem), answering machines
and cordless phones.