13
4. HANDSFREE OPERATION
To commence a Handsfree call press HANDSFREE/HEADSET; the telephone will activate the line, and
the speaker, and the indicator will switch on to provide confirmation. Dialing and speech can then
commence. Pressing the key again will terminate the call. The Handsfree state is storable in the Direct
Access memory keys – please see the MEMORY OPERATION section.
The Handsfree mode will be disabled if a headset is connected to the headset jack.
Incoming calls using Handsfree
1. Telephone rings
2. Press HANDSFREE/HEADSET
3. Commence your handsfree conversation.
Outgoing calls using Handsfree (manual or memory dialing)
1. Press HANDSFREE/HEADSET
2. Dial required number or press desired memory key
3. Speak as necessary.
Changing from Handsfree to Handset during a call
Lift Handset and resume your conversation; the handsfree function will switch off automatically.
Changing from Handset to Handsfree during a call
1. Press HANDSFREE/HEADSET
2. Replace Handset
3. Resume your conversation in Handsfree mode.
HINTS FOR HANDSFREE OPERATION
As a courtesy, tell the other party that you are using the handsfree function. He/She may or may not
want people other than you to hear the conversation. A quiet environment ensures best handsfree
performance. When handsfree is used in a noisy room or near a noise generating device (for example,
a TV set), all or part of the message may be interrupted and cannot be heard. To eliminate this problem,
try to lower the noise level in the room.
During the handsfree conversation, your telephone will give priority to the person who speaks louder
when both people are talking simultaneously. Speak ONLY after the other person pauses or stops.
If the other person complains about poor transmission, talk directly at your telephone and from a closer
distance as necessary, or lower volume control.
If the operation of the handsfree feature is not correct, refer to the FAILURE TO OPERATE section.
To Next Page
Loading...
