29
9. INSTALLATION
GENERAL SETTING-UP
1. Fit the coiled cord to the appropriate sockets in the handset and the telephone base - please do not
connect it to the headset socket at the rear
2. Fit the line cord to the line socket and to your telephone network outlet
3. Set the Ringer Volume and the Ringer Pitch controls
4. See following sections to complete the installation
5. If using a headset, connect it to the headset jack shown in Figure 2B.
LINE CONNECTION
This telephone is supplied with a line cord and plug compatible with both 8 pin modular and 6 pin
modular wall sockets , with the centre pair being used for all telephony functions. Other types of plugs
and cords are available on request.
LOCATION
The telephone should be placed on a desk, table or shelf where it is not likely to be pushed off. If the unit
is to be wall-mounted, it should be seated securely on the IQ335 Wall Mount Bracket illustrated in
Figure 6B (please order separately). Avoid excessive heat, damp, dust, direct sunlight, vibration, and
other appliances or devices which may transmit or emit electrical or electromagnetic radio frequency
noise or signals (e.g. computers, welders, pagers).
WALL MOUNTING
Use the IQ335 Wall Mount Bracket or Wall Mount Kit No.4 shown in Figure 6B (please order separately).
1. To enable the Handset to be supported in the cradle, follow the procedure shown in Figure 6A to
reverse the Handset Retainer
2. Connect the link cord as shown
3. Fit the IQ335 wall mount bracket (optional, not supplied) to the underside of the telephone and
mount on the 7626 modular wall jack (see Figure 6B).
To Next Page
Loading...
