Interquartz IQ335 - Automatic Pause Insertion; Pause Time

27
To setup, model IQ335 accepts a one or two digit Trunk Access Code as follows:
1. Press STORE
2. Enter the Trunk Access digit (example, 0 for Customnet)
3. Press STORE
4. Press “ ”
After programming digit 0 in the above example the unit will insert a 0 in front of any outgoing number that is
dialed from the Calls list (the list of incoming calls).
This setting remains set until the user changes it - removal of power sources or line connection will not
change the setting.
Automatic Pause Insertion
The above procedure will also insert a pause after the access code before dialing the actual number
that has been selected for call-back from the Calls list. The pause time can be pre-set (see below).
PAUSE TIME
Sometimes the standard Pause time of 1 Second may be inappropriate, such as when a shorter pause
is needed to slow down a code stored in memory so that the telephone does not dial too quickly for the
network.
EXAMPLE: A particular network typically needs a short pause in the Call Hold function code after
“Recall” is sent to line and before “ 74” is dialed. A pause time of 200mSec is required in that code
sequence. The required Call Hold code is Recall, Pause (insert multiple pause(s) here), ,74.
Solution: Change the Pause time from the factory default of 1 Sec to 100mSec, and then program the
memory with enough pauses inserted in the code to achieve the desired pause time.
FIRST change the pause time to 100mSec
1. Press STORE; the display will show “STORE”
2. Press , , STORE; the display will show “1-RECALL 2-PAUSE”
3. Press 2 to enter Pause Time Selection; the display will show “PAUSE 1 SEC” (the factory default Pause
time)
4. Press Scroll (the one above the DIAL key) Up or Down to select 100mS
5. Press STORE to confirm selection; the display will show “PAUSE STORED”.
THEN program the Call Hold function code with 200mSec of Pause time (two 100mSec Pauses) as follows:
1. Press STORE; display shows “STORE”
2. Press any memory key; the display shows “ENTER NUMBER”
3. Press RECALL, PAUSE (twice), , 74; the display shows “FPP 74”
4. Press STORE; the display shows “ENTER NAME”
5. Enter text “CALL HOLD” on the keypad
6. Press “STORE”; the display shows “MEMORY STORED”
7. Test for resulting pause time stored in that memory key for network compatibility by pressing that memory
key at the appropriate time and observing the result.