5
Version 2.0 (11/2013) en
Translation of the original instructions
DriveControl DC-20/DC-54
Safety
Dangers
Bodily injury Maintenance or repair work must only be performed by authorized and
qualified persons in accordance with the applicable regulations.
Before using the DriveControl, ensure that no unauthorized persons are near
the conveyor.
Electricity
Only operate the DriveControl with control voltages that are in compliance
with the requirements of EN 60401-1, PELV.
Only perform installation and maintenance work after you have switched off
the power.
Ensure that the power cannot be turned on accidentally.
Working environment
Do not use the DriveControl in areas where there is a hazard of explosion.
Remove equipment or material which is not required from the workspace.
Faults during operation
Regularly inspect the DriveControl for visible damage.
If you notice smoke, switch off the power immediately and ensure that it
cannot be switched on again accidentally.
Contact qualified personnel immediately to find the source of the fault.
Maintenance
Because the product does not require maintenance, you only need to inspect
the DriveControl regularly for visible damage and that all cables and screws
are firmly in place.
Accidental motor starts
Exercise caution when installing or performing maintenance on the
DriveControl 20/54 and when troubleshooting, as a start signal may
accidentally be triggered, unintentionally starting one of the connected
motors.
Interfaces to other devices
By assembling the DriveControl in a conveyor module, further hazards may
occur. These hazards are not part of this manual and have to be analyzed during
the design, installation and startup of the conveyor module.
After assembling the DriveControl in a conveyor module, check the whole
system for a new potential dangerous spot before switching on the conveyor.
Important
The following list provides information about the various types of danger or
damage that may occur while working with the DriveControl 20/54.
To Next Page
Loading...
