Interroll DriveControl 20 - Initial Startup and Operation; Commissioning

23
Version 2.0 (11/2013) en
Translation of the original instructions
DriveControl DC-20/DC-54
Initial startup and operation
Commissioning
Pre-commissioning checks  Ensure that the DriveControl has been correctly fastened to the profile and
that all screws have been correctly tightened.
 Ensure that there are no additional areas of danger caused by interfaces to
other components.
 Ensure that the wiring is in accordance with the specification and legal
directives.
 Check all protection devices.
 Ensure that no personnel stand in hazardous areas near the conveyor.
Pre-commissioning checks
 Check the DriveControl for visible damage.
 Check the DIP switch settings (see "DIP switches", page 12).
 Check all protection devices.
 Clearly specify and monitor the way goods are placed on the conveyor.
 Ensure that the RollerDrive is not blocked.
 Ensure that no personnel stand in hazardous areas near the conveyor.