33
Version 2.0 (11/2013) en
Translation of the original instructions
DriveControl DC-20/DC-54
Appendix
Installation declaration
in accordance with the EC Machinery Directive 2006/42/EC, Appendix II B,
the manufacturer:
hereby declares with sole responsibility that the product range
• DriveControl 20
• DriveControl 54
is not a ready-to-use machine as defined by the EC Machinery Directive
and, therefore, does not fully comply with the requirements of this
directive. The commissioning of these modules is not permitted until
conformity of the entire machine/system in which they are installed has
been declared in compliance with the EC Machinery Directive and the EMC
directive.
The health and safety requirements as stated in Appendix I have been applied.
The special technical documents mentioned in Appendix VII B have been
prepared and will be sent to the responsible authority if necessary.
Person authorized to prepare the technical documents:
Interroll Engineering GmbH, Hoeferhof 16, D - 42929 Wermelskirchen
Applicable EC directives:
• Machinery Directive 2006/42/EC
• RoHS Directive 2002/95/EC
Applied harmonized standards:
• EN ISO 12100-03 "Safety of machinery - Basic concepts - risk assessment
and reduction"
Wermelskirchen, 31st March 2010
Armin Lindholm
(Managing Director)
(This declaration can be obtained at www.interroll.com, if needed.)
Interroll Engineering GmbH
Hoeferhof 16
D - 42929 Wermelskirchen
Germany
To Next Page
Loading...
