5. Complete Multi-stim
Continue to remove and replace the device from the
skin after each Point-stim to continue Multi-stim.
Repeat this process until Multi-stim is complete.
Multi-stim is complete either when the sequence
of Point-stim values peaks and then falls twice
consecutively or when 8 Point-stims have been
completed (whichever occurs first). When Multi-stim
is complete a check mark will appear in the middle
of the screen, a tone will sound and the green LED
will flash.
-------------------------------------------------------------------------------------------------
6. Slide to Finish
To finish the treatment slide the device in 4 directions
over the treated areas (indicated by the red dot) as
shown below.
23
Red dot represents point of treatment
To Next Page
Loading...