Product Specifications
*Tested for USA FDA regulatory requirements, the peak output voltage of the InterX 5002 is
640V into an open circuit load. The peak voltage is 48V and the peak current is 95mA into
a 500 Ohm resistive load. Tested for IEC – 60601 requirements, the peak negative output
voltage is 640V. The peak positive output voltage is 460V (1.1kV peak to peak) for an open
circuit load. The peak positive output current is 160 mA; the peak negative output current is
25 mA (185 mA peak to peak) for a short circuited output.
Size 220mm X 63mm X 45mm
Weight Approx 330g
Operating Temperature 15 deg C to 40 deg C
Operating humidity 5% - 85% relative humidity (non-condensing)
Storage Temperature -40 deg C to 60 deg C
Storage Humidity 5% - 85% relative humidity (non-condensing)
Power Source 4 AA DC Alkaline batteries
Pulse Duration 10 – 500 micro-seconds
Pulse Frequency in burst mode 120 – 480 pulses per second
Typical Skin Resistance 3000 Ohms
Typical Peak Voltage Output (on skin)* 135 V
Typical Peak Current Output (on skin)* 45 mA
Typical Average Voltage (
on skin)*
17 V
Typical Average Current (on skin)* 6 mA
Electrodes Stainless Steel
Waveform Pulsed, Damped, bi-phasic Sinusoidal
Degree of protection in water IPXO ordinary rating
34
To Next Page
Loading...