Operating Manual for Digital Sound Processor (DSP) V3.0
WWW.INTREND-AV.RU
41
M
ike sets the microphone number: generally corresponding to the input channel of the device, that
is, the channel number connected by the Mike. Priority: the smaller the priority series, the higher the
priority level, when the priority is the same, according to the trigger priority order; if two Macs speak
at the same time, The camera automatically rotates to the preset bit corresponding to a Mike with a
small priority (that is, high priority) or sends a command corresponding to a Mike with a small priority
(that is, high priority); but if the two Macs have the same priority, the first checked signal shall prevail.
preset point, serial port number, camera address, protocol and camera related, must correspond to
the actual connection of the camera. Enable: when the device detects an input signal (usually when
someone speaks), it automatically sends the corresponding command to the defined serial port, and
then it can set the command in advance. But without checking enable Custom Command, the device
does not send automatically, but can still click the send button to send input box command to the
specified serial port. Click Save to save the parameter to the device, when the channel's Mike is
associated with the corresponding camera address. Then the "enable microphone setting" option is
used to determine whether the microphone setting is a camera debugging interface when tracking
is enabled. Finally, the parameters of this part will be saved on the camera.
3.4.19 USB Soundcard
USB soundcard is used to carry out two functions, realizing recording and broadcasting and
teleconferences using personal computers. After going through echo and noise cancellation modules,
USB voice may access to teleconferences easily. USB broadcasting function on the software interface
can only be used for recording and broadcasting function.
To Next Page
Loading...
Need help?
General