What to do if SVR LED never lights on Intuicom Network Hardware?
If the SVR LED never lights on your Intuicom Network Hardware, configure the Server IP Address and Port, as the unit may be unable to establish a TCP socket connection to the server due to an incorrect Server Address or Port Configuration.
Lists the primary capabilities and functionalities of the RTK Bridge.
Details the physical ports, buttons, and LEDs on the RTK Bridge front panel.
Illustrates typical use cases and scenarios for the RTK Bridge.
Explains how to utilize the RTK Bridge with external third-party radios.
Describes extending data service range for rovers using cellular.
Explains how to connect a PC to the RTK Bridge to access its configuration interface.
Details the process of activating the internal cellular modem for network connectivity.
Specific steps for establishing and activating Verizon cellular service for the device.
Steps for establishing and activating GSM/GPRS/EDGE cellular service.
Configuration of APN, username, and password for cellular network access.
Outlines the process of setting up the four configurable Profiles for the RTK Bridge.
Details Profile selection, connection modes, server IP, port, and NTRIP mountpoint.
Covers GPS positioning reporting and network server authentication setup.
Configuration options for the internal 900MHz spread spectrum data radio.
Settings for Data Port baud rate, Network ID, packet sizes, and repeaters.
Access to unit maintenance, firmware upgrades, and advanced wireless settings.
Fundamental steps for physically setting up and preparing the RTK Bridge for operation.
Describes the unit's boot-up process and the meaning of status indicators.
Explains the status indicated by the PWR, GPS, SIG, MDM, SVR, TXD, and Profile LEDs.
Monitoring current operational status and messages via the Config Port.
Special mode for aiming directional cellular antennas to optimize signal strength.
How to switch between configured operational profiles without using a PC.
Tips for improving range and performance of the wireless data radio network.
Steps to connect the RTK Bridge to external third-party radios for data transmission.
Lists common problems and their corresponding solutions for the RTK Bridge.
Lists the various kits and accessories available for the RTK Bridge.
Provides contact details for obtaining technical assistance from Intuicom.
Information regarding FCC rules and compliance for the device.
Details the limited warranty coverage and terms for Intuicom products.
General| Model | RTK Bridge |
|---|---|
| Power Supply | 9-36 VDC |
| Manufacturer | Intuicom |
| Category | Network Hardware |
| Frequency | 900 MHz |
| Data Link Protocol | Serial |
| Connectivity | Ethernet, Serial |
To Next Page