Unpacking Instructions
1-150-068-A CS Bed Manual.doc © Carroll Healthcare Inc. Page 14 of 35
Cut the plastic tie holding the head
panel to the frame.
Cut the plastic tie holding the knee-foot
panel to the frame.
Untie the mattress keepers.
Untie the hand pendant twist ties. Carefully cut the untrimmed plastic tie
securing the mains power cable bundle.
Plug power cord into a properly
grounded 120V~
Press HILO UP button on the hand
pendant.
After bed is raised, untie the twist ties
on the wall bumper.
Rotate the wall bumper to the floor at
the head end of the bed.
To Next Page
Loading...
