Invacare Carroll CS - Care and Maintenance; Sanitizing Method

Care and Maintenance
1-150-068-A CS Bed Manual.doc © Carroll Healthcare Inc. Page 27 of 35
CARE AND MAINTENANCE
Sanitizing Method
Equipment or property DAMAGE or resident INJURY may occur during maintenance.
Cleaning Instructions
1. Unplug product before washing.
2. Make sure all electrical parts (motors, control box and pendant) are not damaged and that all
connection ports are plugged. DO NOT allow liquids to enter electrical components.
3. Disinfect and wash all components. DO NOT submerge the bed frame or electrical parts.
4. DO NOT power wash or steam-clean. Use household water pressure.
5. Rinse thoroughly with water (maximum temperature 110°F or 43°C). DO NOT use solvents, alcohol or
petroleum products on the surface
6. Dry all components before storing.
Annual Maintenance Check
Failure to maintain your bed may reduce product life and increase unplanned maintenance.
 Inspect the covering of the bed’s control panel and the patient control panel to assure that the
covering is not cracked or damaged.
 Inspect for damaged or loose wiring. Have a qualified technician replace any frayed or damaged
cords.
 Inspect for secure grounding.
 Inspect rail latches. Ensure that all rails engage and lock as specified.
 Inspect bed, rails, Assist Rails or Assist Bars for the presence of tubing end caps and replace as
required.
 Tighten, adjust or replace any parts or bolts etc. that are loose or show signs of wear.
 Lubricate clevis pins at all mechanical hinge points.
 Inspect for wear on clevis pins and hitch pins and replace if worn or missing.
If epoxy coated rails become scratched or chipped, use a matching enamel touch up paint. (Refer to
Options for paint specification).
Quarterly Maintenance Check
 Unplug bed from wall outlet and verify battery function, if equipped. (Battery may be built-in or
portable)