17
OPERATION AND SET-UP ON THE CONTROLLER
inVENTer Connect controller platform | Operating instructions
Inner cover, sensor technology, switching contact
The inner cover, sensor technology and switching contact only need to be operated during initial
setup or after restarting the ventilation system. If they are paired with the controller and thus
integrated into the ventilation system, they communicate and/or supply the measured values auto-
matically. No further operation on the devices is required; settings are made via the controller.
During initial commissioning, a button on the device is used for operation. A multi-coloured
status LED (position see 2.2: Inner cover and 2.3: Sensor system) shows the status of the
respective device by lighting up in dierent colours.
The following displays are possible and uniform for all devices to be paired:
LED colour LED state Status of the controller
TURQUOISE Solid Device not paired
GREEN Flashing Devices are paired
GREEN Solid Device pairing completed
Table 3: Status LED display of paired devices
To Next Page
Loading...