inVENTer Connect. - Page 43

43
OPERATION AND SET-UP ON THE CONTROLLER
inVENTer Connect controller platform | Operating instructions

The boost symbol ashes on the display screen and
the boost function time setting (timer) appears at
the same time.
► Press the up and down arrow keys to set
the desired time for boost mode.
When setting the boost time, you can choose be-
tween 1, 2, 4 and 8 hours.
► Press the select key to conrm the se-
lected time setting.

The desired boost time is set for the selected
ventilation zone,
here e.g. 1 hour.

The display screen shows the zone
status (system information) for the ventilation zone
that is in boost function, here ventilation zone 2.

Alternating with the zone status, the remaining
boost time is displayed.
The set boost time is displayed alternately with the
zone status until it expires.
↔↔