Remote
Control
+ button
Can be used to set Temperature / Timer functions
Pressing this button will increase the temperature in
the cool mode. On pressing and holding this button
for more than 2 seconds, the units will increase rapidly
until the button is released, On releasing the button
the setting is applied after a beeping sound is
produced. In Auto mode, the temperature cannot be
set, but pressing this button will make a beeping
sound. Operating temperature range is 16℃ - 30℃.
Timer
TIMER button
- You can set both pre-set stop and delayed start while unit is in
ON position or OFF position.
When unit is in ON position, first press TIMER button to go to
Pre-set stop setting, then “T-OFF” light will illuminate, tap or hold
the + button or the - button to change delay stop timer at 0.5 hour
increments up to 24 hours. Then press the TIMER button to
confirm the setting (the control will confirm the setting
automatically after 5 seconds) and go to delay start setting.
Use the same way as above to set the delay start timing. If you
don’t need to set delay start, press the TIMER button again to
exit. After 2 seconds, the control will automatically change the
display back to previous temperature display. If you want to check
remain timing, press the TIMER button. The delay start operation
automatically selects mode, temperature and fan speed the same
as last operation you set.
When unit is in OFF position, press TIMER button will first go to
delay start setting, then “T-ON” light will illuminate, set the delay
start and delay stop timing the same way as above.
To cancel the timer setting, simply tap Timer button to cancel and
the timer setting will be cancelled. This can be confirmed by
noticing that the T-ON and T-OFF arrow will disappear.
- button
Can be used to set Temperature / Timer functions
Pressing this button will decrease the temperature in
the cool mode. On pressing and holding this button
for more than 2 seconds, the units will decrease
rapidly until the button is released, On releasing the
button the setting is applied after a beeping sound is
produced. In Auto mode, the temperature cannot be
set, but pressing this button will make a beeping
sound. Operating temperature range is 16℃ - 30℃
10
To Next Page
Loading...
Need help?
General
Weight and Dimensions
