DRAINAGE METHOD
During the process of cooling or drying, excess condensation will occur inside the unit, although the water
will be evaporated by the coil for maximum efficiency. In very warm temperature or high humidity condition,
it will require water drainage. When the internal water tank is full the buzzer will beep 8 times as a warning,”
“water full indicator will light up on the panel with H8 displayed on LED display window and the unit will
stop working. For the unit to resume operation water should be drained out of the unit from the drainage
hose. Remove the drain hose from the clamp and release the excess water at downward slope by removing
the rubber plug. The unit will resume running when the water is completely drained from the unit out of the
hose or the drain port.
INSTALLATION OF DRAINAGE HOSE
Note: The drainage hose must be installed before operating the unit otherwise a blockage may occur
affecting the normal operation of the unit.
- Drain Hose included:
- Installation of Drain Hose
1. Remove drain cap (B) from drain port (A).
12
To Next Page
Loading...
Need help?
General
Weight and Dimensions
