VS070QS-1618MDM1 Integrated Machine Product overview
202403 (V1.0) 19
2.3.7.2 Output connection instance of analog signal
Figure 2-3 Voltage mode output
Figure 2-4 Current mode output
For analog output, it is recommended to use shielded twisted-pair cables. The
cable shall be kept away from power cables or other cables that may cause
electrical interference.
Using single-point grounding on the load end of the output cable.
If there is electrical noise or voltage fluctuation during outputting, a smoothing
capacitor (0.1 μF–0.47 μF/25 V) is recommended.
If voltage output short circuit occurs or the current load is connected to the
voltage output end, VS070-1614MDR1 integrated machine may be damaged.
Analog power supply not only can use 24 V DC power supply output by the main
module, but can use other power supplies that meet the requirements.
Do not use the unconnected pin on the user terminals.
The analog signal input/output specification is listed in the following table. The
analog quantity is non-isolated.
To Next Page
Loading...