VS070QS-1618MDM1 Integrated Machine Safety precautions
202403 (V1.0) 2
Delivery and installation
equipment related knowledge from touching by mistake, since the
mistake may result in equipment damage or electric shock. Only
personnel who have received related electrical knowledge and
equipment operation training can operate the control cabinet.
Do not run a damaged or incomplete product.
Do not contact the product with damp objects or body parts.
Otherwise, electric shock may result.
Fully understand the interface types, specifications, and related
requirements before wiring. Otherwise, incorrect wiring cause
abnormal running.
Before power-on for running, ensure that each module terminal
cover is properly installed in place after the installation and wiring
are completed. This prevents a live terminal from being touched or
misoperation. Otherwise, physical injury or equipment fault may
result.
Install proper protection components or devices when using
external power supplies for the product. This prevents the
programmable controller from being damaged due to external
power supply faults, overvoltage, overcurrent, or other exceptions.
Commissioning and running
Before power-on for running, ensure that the working environment
of the product meets the requirements, the input power
specifications meet the requirements, the wiring is correct, and a
protection circuit has been designed to protect the product so that
the product can run safely even if an external device fault occurs.
For modules or terminals requiring external power supply,
configure external safety devices such as fuses or circuit breakers
to prevent damage caused due to external power supply or device
faults.
Maintenance and component replacement
During maintenance and component replacement, take measures
to prevent screws, cables and other conductive matters from
falling into the internal of the product.
To Next Page
Loading...