Three-phase Grid-tied Solar Inverter Inverter storage
12
3 Inverter storage
If the inverter is not put into use immediately, the storage of inverter should meet the following
requirements:
Do not remove the inverter outer package.
The inverter needs to be stored in a clean and dry place, and to prevent the erosion of dust and
moisture.
The storage temperature should be kept at -30℃~+70℃, and the relative humidity should be kept at
5%RH~95%RH.
If multiple inverters to be stacked, it is recommended to place them according to the original stacking
layer number at the time of delivery. When stacking, please place the inverter carefully to avoid
personal injury or equipment damage caused by equipment tipping.
Avoid chemical corrosive substances, otherwise it may corrode the inverter.
During storage, regular inspections are required. If insect bites or packaging damage are found, the
packaging materials must be replaced in time. After long-term storage, the inverter needs to be
inspected and tested by professionals before it can be put into use.
To Next Page
Loading...
