Three-phase Grid-tied Solar Inverter Installation
18
Step 2: Use a hammer drill to drill holes and install expansion bolts. Users need to prepare
expansion bolts by themselves. It is recommended to use M8×60 stainless steel pressure explosion
expansion bolts.
Step 3: Fix the hanging board. Clean the holes, use a rubber hammer to drive the expansion bolt
into the hole, use a wrench to tighten the nut to fix the end of the bolt, then remove the nut, spring washer
and flat washer, and then fix the wall mount plate to the wall and lock it with a tightening torque of
13N*m。.
4.6 Install the inverter
Step 1: Take the inverter out of the packaging box.
Step 2: If the installation location is high, you need to lift the inverter to the hanging plate, use the
lifting equipment to lift the inverter 100mm off the ground and then pause, check the tightness of the
hoisting ring and rope. After confirming that the connection is secure, lift the inverter to the destination.
To Next Page
Loading...
