Three-phase Grid-tied Solar Inverter Installation
17
(3) When installing multiple inverters, a certain distance shall be reserved between the inverters, as
shown in Figure 4.4. At the same time, sufficient distance shall be reserved between the upper and lower
parts of the inverter to ensure good heat dissipation。
Fig 4.5 Size requirements for side-by-side installation
(4) The installation surface should be perpendicular to the horizontal line, as shown in Figure 4.5.
Please install the inverter vertically or backward ≤15° to facilitate the heat dissipation of the machine. Do
not tilt the inverter forward, horizontally, upside down, leaning too far, or tilting to the side.
Fig 4.6 Installation position of inverter
4.4 Mounting board size
Fig 4.7 Dimensions of the mounting plate
4.5 Wall installation
Step 1: Place the hanging board on the wall mounting point, use a level to adjust the angle, and
mark with a marker.
To Next Page
Loading...
